diff options
| -rw-r--r-- | rc.inet1 | 94 | ||||
| -rw-r--r-- | rc.inet1.conf | 44 |
2 files changed, 71 insertions, 67 deletions
@@ -397,27 +397,8 @@ if_up() { /sbin/ip link set dev ${1} down fi fi - if [ "${USE_DHCP[$i]}" != "yes" ] && [ -n "${IPADDR[$i]}" ]; then # add a fixed v4 IP to the interface - info_log "${1}: setting fixed IPv4 address" - if [ -z "${NETMASK[$i]}" ]; then - info_log "${1}: no NETMASK set for primary IP ${IPADDR[$i]} - assuming 24 (aka, 255.255.255.0)" - NETMASK[$i]="24" - fi - debug_log "/sbin/ip -4 address add ${IPADDR[$i]}/${NETMASK[$i]#/} broadcast + dev ${1}" - if /sbin/ip -4 address add ${IPADDR[$i]}/${NETMASK[$i]#/} broadcast + dev ${1} && \ - /sbin/ip link set dev ${1} up; then - IF_UP=1 - else - info_log "${1}: failed to set IP ${IPADDR[$i]}" - debug_log "/sbin/ip address flush dev ${1}" - /sbin/ip address flush dev ${1} - debug_log "/sbin/ip link set dev ${1} down" - /sbin/ip link set dev ${1} down - fi - fi - if [ -e /proc/sys/net/ipv6 ] && [ "${USE_DHCP6[$i]}" != "yes" ] && [ "${USE_SLAAC[$i]}" != "yes" ] && \ - [ -n "${IP6ADDRS[$i]}" ]; then # add fixed v6 IPs - info_log "${1}: setting fixed IPv6 addresses" + if [ -e /proc/sys/net/ipv6 ] && [ -n "${IP6ADDRS[$i]}" ]; then # add v6 IPs + info_log "${1}: setting IPv6 addresses" # IPv6's Duplicate Address Detection (DAD) causes a race condition when bringing up interfaces, as # described here: https://www.agwa.name/blog/post/beware_the_ipv6_dad_race_condition # Disable DAD while bringing up the interface - but note that this means the loss of detection of a @@ -432,8 +413,7 @@ if_up() { PREFIX="64" fi debug_log "/sbin/ip -6 address add $IP/$PREFIX dev ${1}" - if /sbin/ip -6 address add $IP/$PREFIX dev ${1} && \ - /sbin/ip link set dev ${1} up; then + if /sbin/ip -6 address add $IP/$PREFIX dev ${1} && /sbin/ip link set dev ${1} up; then # Enable accepting of RA packets if explicitly told to. if [ "${USE_RA[$i]}" = "yes" ]; then debug_log "${1}: unconditionally accepting IPv6 RA" @@ -454,27 +434,55 @@ if_up() { debug_log "${1}: resetting IPv6 DAD to default" cat /proc/sys/net/ipv6/conf/default/accept_dad >/proc/sys/net/ipv6/conf/${1}/accept_dad fi - if (($IF_UP == 1)); then # only do further config if the interface came up - info_log "${1}: setting fixed IPv4 alias addresses" - # Add extra IPv4 addresses to the interface: - if [ -n "${IPALIASES[$i]}" ]; then - NUM=0 - for IPALIAS in ${IPALIASES[$i]}; do - IP="${IPALIAS%/*}" - NM="${IPALIAS#*/}" - if [ -z "$NM" ] || [ "$IP" == "$NM" ]; then - info_log "${1}: no netmask set for alias IP $IP - assuming 24 (aka, 255.255.255.0)" - NM="24" - fi - debug_log "/sbin/ip -4 address add $IP/$NM broadcast + dev ${1} label ${1}:$NUM" - if /sbin/ip -4 address add $IP/$NM broadcast + dev ${1} label ${1}:$NUM; then - NUM=$(($NUM + 1)) - else - info_log "${1}: failed to add alias IP $IP" - fi - done + if [ -n "IPADDRS[$i]" ] || [ -n "IPADDR[$i]" ]; then # add v4 IPs + info_log "${1}: setting IPv4 addresses" + # Only use IPADDR if no dynamic configuration was done. + if [ "${USE_DHCP[$i]}" == "yes" ] || [ "${USE_DHCP6[$i]}" == "yes" ] || [ "${USE_SLAAC[$i]}" == "yes" ]; then + V4IPS="${IPADDRS[$i]}" + else + V4IPS="${IPADDRS[$i]} ${IPADDR[$i]}${NETMASK[$i]:+/${NETMASK[$i]}}" fi - # Force an MTU (possibly over-riding that set by DHCP or RA): + for V4IP in $V4IPS; do + IP="${V4IP%/*}" + NM="${V4IP#*/}" + if [ -z "$NM" ] || [ "$IP" == "$NM" ]; then + info_log "${1}: no netmask set for IP $IP - assuming 24 (aka, 255.255.255.0)" + NM="24" + fi + debug_log "/sbin/ip -4 address add $IP/$NM broadcast + dev ${1}" + if /sbin/ip -4 address add $IP/$NM broadcast + dev ${1} && /sbin/ip link set dev ${1} up; then + IF_UP=1 + else + info_log "${1}: failed to set IP $IP" + if (($IF_UP != 1)); then # if at least one address was configured, don't flush the device + debug_log "/sbin/ip address flush dev ${1}" + /sbin/ip address flush dev ${1} + debug_log "/sbin/ip link set dev ${1} down" + /sbin/ip link set dev ${1} down + fi + fi + done + fi + if (($IF_UP == 1)) && [ -n "${IPALIASES[$i]}" ]; then # Only apply IPALIASES onto an up interface + info_log "${1}: setting extra IPv4 addresses" + NUM=0 + for EXTRAIP in ${IPALIASES[$i]}; do + IP="${EXTRAIP%/*}" + NM="${EXTRAIP#*/}" + if [ -z "$NM" ] || [ "$IP" == "$NM" ]; then + info_log "${1}: no netmask set for alias IP $IP - assuming 24 (aka, 255.255.255.0)" + NM="24" + fi + debug_log "/sbin/ip -4 address add $IP/$NM broadcast + dev ${1} label ${1}:$NUM" + if /sbin/ip -4 address add $IP/$NM broadcast + dev ${1} label ${1}:$NUM; then + NUM=$(($NUM + 1)) + else + info_log "${1}: failed to add alias IP $IP" + fi + done + fi + if (($IF_UP == 1)); then + # Force an MTU (possibly overriding that set by DHCP or RA): if [ -n "${MTU[$i]}" ]; then info_log "${1}: setting custom MTU" debug_log "/sbin/ip link set dev ${1} mtu ${MTU[$i]}" diff --git a/rc.inet1.conf b/rc.inet1.conf index 5081ee5..48b94db 100644 --- a/rc.inet1.conf +++ b/rc.inet1.conf @@ -17,49 +17,45 @@ # ============================================================================= -# IPv4 config information for eth0: -IPADDR[0]="" -NETMASK[0]="" -IPALIASES[0]="" +# IPv4 config options for eth0: +IPADDRS[0]="" USE_DHCP[0]="" -DHCP_HOSTNAME[0]="" -# IPv6 config information for eth0: +# IPv6 config options for eth0: IP6ADDRS[0]="" USE_SLAAC[0]="" USE_DHCP6[0]="" +# Generic options for eth0: +DHCP_HOSTNAME[0]="" -# IPv4 config information for eth1: -IPADDR[1]="" -NETMASK[1]="" -IPALIASES[1]="" +# IPv4 config options for eth1: +IPADDRS[1]="" USE_DHCP[1]="" -DHCP_HOSTNAME[1]="" -# IPv6 config information for eth1: +# IPv6 config options for eth1: IP6ADDRS[1]="" USE_SLAAC[1]="" USE_DHCP6[1]="" +# Generic options for eth1: +DHCP_HOSTNAME[1]="" -# IPv4 config information for eth2: -IPADDR[2]="" -NETMASK[2]="" -IPALIASES[2]="" +# IPv4 config options for eth2: +IPADDRS[2]="" USE_DHCP[2]="" -DHCP_HOSTNAME[2]="" -# IPv6 config information for eth2: +# IPv6 config options for eth2: IP6ADDRS[2]="" USE_SLAAC[2]="" USE_DHCP6[2]="" +# Generic options for eth2: +DHCP_HOSTNAME[2]="" -# IPv4 config information for eth3: -IPADDR[3]="" -NETMASK[3]="" -IPALIASES[3]="" +# IPv4 config options for eth3: +IPADDRS[3]="" USE_DHCP[3]="" -DHCP_HOSTNAME[3]="" -# IPv6 config information for eth3: +# IPv6 config options for eth3: IP6ADDRS[3]="" USE_SLAAC[3]="" USE_DHCP6[3]="" +# Generic options for eth3: +DHCP_HOSTNAME[3]="" # IPv4 default gateway IP address: GATEWAY="" |